Text
Prosedur ketelitian geometrik mesin frais tipe konvensional melalui pengujian karekteristik statik menurut ISO 1701 di laboratorium produksi Jurusan Teknik Mesin Universitas Negeri Jakarta
ABSTRAK
IRSAD SIDIK, Prosedur Ketelitan Geometrik Mesin Frais Tipe Konvensional Melalui Pengujian Karakteristik Statik Menurut ISO 1701 Di Laboratorium Produksi Universitas Negeri Jakarta. Skripsi, Jakarta: Program Studi Pendidikan Teknik Mesin, Jurusan Teknik Mesin, Fakultas Teknik, Universitas Negeri Jakarta, 2015.
Penelitian ini bertujuan untuk mengetahui nilai penyimpangan terbesar ketelitian geometrik mesin frais Chevalier dan mesin frais Fortworth berdasarkan ISO 1701. Metode yang digunakan untuk penelitian adalah dengan pengambilan data langsung pada mesin frais Chevalier dan Fortworth berdasarkan ISO 1701. Pengujian yang dilakukan ialah kedataran permukaan meja, ketegaklurusan antara permukaan meja dengan gerak vertikal lutut arah melintang dan mendatar, kelurusan gerak vertikal lutut arah melintang dan mendatar, kesejajaran antara permukaan meja dan gerak longitudinal, penyimpangan putar dari permukaan luar spindel.
Hasil penelitian menunjukkan pada mesin frais Chevalier ketiga jenis pengujian tidak memenuhi ISO 1701, kecuali pada pengujian kedataran permukaan meja dan pengujian penyimpangan putar dari permukaan luar spindel. Pada mesin frais Fortworth, kedua jenis pengujian tidak memenuhi standar ISO 1701, kecuali pada pengujian kedataran permukaan meja, kesejajaran antara permukaan meja dan gerak longitudinal, penyimpangan putar dari permukaan luar spindel.
ABSTRACT
IRSAD SIDIK, Geometric Accuracy Procedure Frais Machines Conventional Type Through Static Characteristics Testing According to ISO 1701 in Manufacture Laboratory of the State University of Jakarta. Thesis, Jakarta: Study Program of Mechanical Engineering, Department of Mechanical Engineering, Faculty of Engineering, State University of Jakarta, in 2015
This study aims to determine the value of the largest deviation of geometric precision milling machine Chevalier and milling machine Fortworth based on ISO 1701. The method used for the study is to capture the data directly to the milling machine Chevalier and Fortworth based on ISO 1701. Testing performed is flatness of the table surface, squareness between the table surface and the vertical movement of the knee direction transverse and horizontal, paralellism between the table surface and longitudinal movement, run out of the external centring surface on the spindle nose.
The results showed the Chevalier milling machine three types of testing do not meet ISO 1701, except on the flatness of the table surface and testing of run out of the external centring surface on the spindle nose. At Fortworth milling machine, two types of tests do not meet the standards of ISO 1701, except on the test flatness of the table surface, parallelism between the table surface and longitudinal movement, run out of the external centring surface on the spindle nose.
Bibliografi : lembar 110
SS00007980 | SK 7980 | UPT Perpustakaan UNJ | Tersedia |
Tidak tersedia versi lain