Text
Prototipe sistem pendeteksi bahaya kebakaran berbasis IoT (Internet of Things)
Penelitian bertujuan untuk merancang sistem pendeteksi bahaya kebakaran berbasis IoT (Internet of Things). Penelitian dilaksanakan di laboratorium instrumentasi fakultas teknik Universitas Negeri Jakarta pada Juni 2017– Januari 2018. Penelitian menggunakan metodologi rekayasa teknik yang meliputi analisis kebutuhan sistem, perancangan sistem, menentukan subsistem, perancangan software, pengujian subsistem dan software, analisis pengujian, implementasi hardware dan software. Penelitian prototipe sistem pendeteksi bahaya kebakaran terdiri dari 3 subsistem utama, yaitu input, proses, dan output. Subsistem input terdiri dari 3 buah modul sensor yang terdapat pada 4 ruangan yang digunakan untuk mendeteksi bahaya kebakaran. Personal computer / laptop dan smartphone sebagai penampil hasil yang diperoleh oleh modul sensor. Subsistem proses yaitu ESP8266 NodeMCU akan mengirimkan data menuju database dan akan ditampilkan pada website sebagai interface. Subsistem output yaitu buzzer yang digunakan sebagai alarm ketika terdeteksi bahaya kebakaran dan fan yang digunakan sebagai penetralisir ruangan agar asap dan gas yang dideteksi dapat berkurang dan ruangan kembali normal. Hasil penelitian menunjukkan prototipe sistem pendeteksi bahaya kebakaran dapat mendeteksi api (yang dihasilkan dari nyala api korek), mendeteksi suhu >40°C yang ditimbulkan dari api, mendeteksi gas (yang dihasilkan dari korek gas), dan mendeteksi asap (yang dihasilkan dari rokok/obat nyamuk bakar). Ketika bahaya kebakaran terdeteksi maka buzzer akan aktif sebagai alarm dan hasil pembacaan modul sensor akan dikirimkan menuju halaman website. Jika terdeteksi bahaya kebakaran maka tampilan pada halaman website akan berwarna merah, sedangkan jika bahaya kebakaran tidak terdeteksi maka halaman website akan berwarna hijau. Halaman website dapat dipantau dari jarak jauh, jika terkoneksi dengan internet.
Study aims to design a fire hazard detection system based IoT (Internet of Things). essay. The research was conducted in Instrumentation Laboratory of Faculty of Engineering, State University of Jakarta in June 2017–January 2018. Research uses Engineering Methodology which system requirement analysis, system design, subsystem, software design, subsystem and software testing, test analysis, hardware and software implementation. Research of prototype fire hazard detection system consists of 3 main subsystem, that is input, process, and output. The input subsystem consists of 3 sensor module contained in 4 rooms where use to fire hazard detection. Personal computer / laptop and smartphone as the result viewer obtained by the sensor module. The process subsystem, ESP8266 NodeMCU, will transmit data to the database and will be displayed on the website as an interface. The output subsystem is buzzer is used as an alarm when fire hazard is detected and the fan used as the neutralizer of the room to detect smoke and detected gases can be reduced and the room back to normal. The results show that prototype fire detection systems can detect fire (generated from flame lights), detect temperature > 40 ° C caused by fire, detect gas (generated from gas lighter), and detect smoke (resulting from cigarette / mosquito coils). When the fire hazard is detected, the buzzer will be active as an alarm and the sensor module reading result will be sent to the website page. If fire is detected then the display on the website page will be red, while if the fire hazard is not detected then the website page will be green. Website page can be monitored remotely, if connected to the internet.
SS00015896 | SK 15896 | UPT Perpustakaan UNJ (CD.05.2018.004) | Tersedia |
Tidak tersedia versi lain