Text
Pengaruh posisi peletakan bata merah pada proses pembakaran secara konvensional terhadap kuat tekan bata merah
Penelitian ini bertujuan untuk mengetahui nilai kuat tekan bata merah berdasarkan posisi peletakkan pada proses pembakaran secara konvensional yaitu posisi atas, posisi tengah dan posisi bawah dalam upaya mendapatkan kuat tekan optimum. Kemudian dilakukan pengujian daya serap air untuk diketahui hubungannya dengan kuat tekan terhadap posisi pembakaran. Penelitian ini dilaksanakan di Laboratorium Uji Bahan Jurusan Teknik Sipil Universitas Negeri Jakarta pada bulan September 2017 – Januari 2018 dengan metode eksperimen sesuai dengan Standar Nasional Indonesia (SNI). Penelitian ini menguji kuat tekan bata merah pada tiap posisi, dan bata merah dipotong menjadi dua bagian kemudian diberi kaping setebal 6 mm. Campuran kaping menggunakan agregat yaitu 1 semen : 3 pasir : 70% air dari berat semen. Jumlah sampel 105 buah bata dengan pembagian : 60 buah bata untuk uji kuat tekan dan 45 buah untuk uji daya serap air. Hasil penelitian menunjukan bahwa nilai rata-rata kuat tekan bata posisi atas sebesar 7,5 MPa, nilai rata-rata kuat tekan bata posisi tengah 10,79 MPa, dan kuat tekan optimum bata merah berada pada posisi bawah dengan nilai rata-rata kuat tekan sebesar 11,83 MPa. Hasil penelitian rata-rata daya serap air bata merah posisi atas sebesar 22,96%, rata-rata daya serap air posisi tengah 19,83%, dan rata-rata daya serap air posisi bawah 19,63%.
Kata kunci : kuat tekan, daya serap air, posisi bata
This research aims to determine the value of red brick pressed strength based on the position of laying on conventional combustion process that is the top position, the middle position and the bottom position in an effort to get the optimum compressive strength. Then tested the water absorption to know the relationship with the compressive strength of the combustion position. This research was conducted at the Laboratory of Materials Test of Civil Engineering Department of State University of Jakarta in September 2017 - January 2018 with experimental method in accordance with Indonesian National Standard (SNI). This study tested the compression strength of the red brick at each position, and the red brick was cut into two parts and then given a 6 mm thick cap. Mixed caps using an aggregate of 1 cement: 3 sand: 70% water from the weight of cement. Number of sample 105 bricks with division: 60 bricks for compressive strength test and 45 pieces for water absorption test. The results showed that the average value of the upper brick strength of the upper brick of 7.5 MPa, the average value of the compressive strength of the middle position of 10.79 MPa, and the optimum strength of the red brick is in the bottom position with the average value of compressive strength of 11.83 MPa. The result of the research is the average of absorption of red brick water up 22.96%, the average of water absorption of the middle position is 19.83%, and the water absorption rate of the bottom position is 19.63%.
Keywords: compressive strength, water absorption, brick position
SS00016359 | SK 16359 | UPT Perpustakaan UNJ (CD.05.2018.002) | Tersedia |
Tidak tersedia versi lain